Description
Enhance PE is an impregnating, low viscosity alcohol-based sealer that will protect and enhance the appearance of concrete, natural stone and masonry surfaces including polished concrete. Enhance PE exhibits good penetration and is fast drying, providing substrates oil and water repellent qualities, whilst being UV resistant and contributing to increased durability of treated surfaces.
Application Instructions
Surface Preparation
Ensure substrate is clean, dust and stain free prior to application. Clean surface to remove any dirt, laitance, previous coatings or curing agents that may prevent penetration of the material.
The surface must be dry prior to application.
It is recommended to undertake a test sample to confirm the suitability of the product for specific substrates and ensure desired results are achieved.
Application Temperature
The air and surface temperature should be between 10°C and 32°C. Do not use in temperatures of less than 10°C. Optimal application conditions 15-25°C.
Application Method
Slowly stir the material until thoroughly mixed; A saturation single coat or two thinner coats of the product, wet on wet, should be applied to achieve a consistent, enhanced appearance with a wet-look. The properties of the substrate such as porosity and profile will greatly influence the number of coats required.
Using a solvent resistant low-pressure sprayer fitted with an adjustable spray tip, apply a thin, even coat of Finseal Enhance PE. Using a soft, lint-free cloth or microfibre mop, spread the product in a thin uniform layer, ensuring no pooling or brush marks.
It is important to remove excess material to prevent inconsistencies in the enhancement. The microfiber pad should be pre-moistened with Finseal Enhance PE prior to use.
Buff surface with a white nylon pad or burnish using a high-speed gas powered burnisher with a Mirafloor diamond-impregnated burnishing pad. Ensure excess material is removed from the surface remains before it dries.
