Miraseal Enhance

Application Instructions

Surface Preparation

Ensure unsealed substrates are clean, dust and stain free prior to application. Clean surface to remove any dirt, laitance, previous coatings or curing agents that may prevent penetration of the material.

The surface must be dry prior to application.

It is recommended to undertake a test sample to confirm the suitability of the product for specific substrates and ensure desired results are achieved.

Best suited to polished concrete surfaces polished in the range of #200 – 3000 resin bonded diamond.

Application Temperature

The air and surface temperature should be between 10°C and 32°C. Do not use in temperatures of less than 10°C. Optimal application conditions 15-25°C.

Application Method

Slowly stir the material until thoroughly mixed; Apply in two or three thin coats of the product, to achieve a consistent, enhanced appearance with a wet look. The properties of the substrate such as porosity and profile will greatly influence the number of coats required.

Using a solvent resistant low-pressure sprayer fitted with an adjustable spray tip, progressively apply a thin, even coat of Miraseal Enhance and in a uniform layer using a soft, lint-free cloth or microfiber mop, ensuring no pooling or mop marks. It is important to remove excess material to prevent inconsistencies in the enhancement. The microfiber pad should be pre-moistened with Miraseal Enhance prior to use.

Buff surface with a white nylon pad or burnish using a high-speed gas powered burnisher with a Mirafloor diamond impregnated burnishing pad, after each coat. Ensure excess material is removed from the surface remains before it dries.

Minor surface tackiness may be present directly after application and this will dissipate after normal traffic and regular cleaning with ph neutral detergent such as Miraclean.